OMTK homepage

Rigid body on springs

Eigenfrequencies and static disturbances of a suspended 3D rigid body

version 01 · 21-11-2026

Calculation tool

Analyze a suspended rigid body under forces and torques, including its deformation, eigenfrequencies and mode shapes. Enter spring directions, connection points, stiffnesses, applied loads and the mass matrix below.

Use a consistent unit system, preferably meters. Direction vectors are normalized; enter actual force components for applied forces.

This is a linear, undamped, small-displacement model. It excludes preload and geometric stiffness.

Diagram of a rigid body supported by springs and subjected to a load

Inputs and visualization

Save or load all inputs as a CSV file. Keep the section names and column headings when editing it.

Enter one spring or load per row. Add as many rows as needed, or paste cells from a spreadsheet.

Linear springs

Applied forces

View linear springs and forces

Red lines: spring directions; blue points: interfaces; green lines and points: applied forces and their application points.

Torsional springs

Applied torques

View torsional springs and torques

Red lines: torque spring axes; green lines: applied torques. Both originate at [0, 0, 0].

View mass matrix input

Enter a symmetric, positive-definite 6×6 mass matrix for the six degrees of freedom, using the same origin and axes as the springs. Verify that it represents a physically valid rigid body.

Calculation results

Applied loads
Static response
Dynamic response
Dynamic response

Each mode is scaled so its largest component has magnitude 1; translations and rotations retain their respective units.

Matrices reflect the last successful calculation. Recalculate after editing inputs.